Question below.....my answer is NO
Has anyone ever seen the adjusting bolt on an inverted fork stick up and out past the flush point of the cap on top??
I saw an older trike in Daytona set up that way...
I am very curious as all bikes and trike over the past 16 years that I have seen have been adjusted to about 1/4 inch down in the hole or a bit further with Bigblocks
Inverted front fork adjustment
- CanuckHoss
- Site Sponsor
- Posts: 2293
- Joined: Mon Nov 23, 2009 11:10 am
- Location: Airdrie, Alberta, Canada
- Contact:
Inverted front fork adjustment
CanuckHoss
Barry Radu, President Destination Cycles
Airdrie, Alberta Canada
"Just BE HAPPY!! BE HAPPY!! BE HAPPY!!"--Abraham
Barry Radu, President Destination Cycles
Airdrie, Alberta Canada
"Just BE HAPPY!! BE HAPPY!! BE HAPPY!!"--Abraham
Re: Inverted front fork adjustment
All of them I remember seeing were down 1/4" or better (trikes and bikes). I remembered seeing one @ the V8 Parade last week that was up above the top of the tubes (it was a trike but don't remember anything more then that).
IF YOU TELL THE TRUTH YOU DON'T HAVE TO REMEMBER ANYTHING