Axle
- Orlando606VetteTrike
- Posts: 310
- Joined: Sun Oct 25, 2015 1:24 pm
- Location: Winter Garden, FL
- Orlando606VetteTrike
- Posts: 310
- Joined: Sun Oct 25, 2015 1:24 pm
- Location: Winter Garden, FL
Re: Axle
Just an FYI, you and Puff were correct at 50 lbs for the 3/4" axle. The 1" axle is 55 lbs per the factory.
2008 606 Corvette Trike
- knockdolian
- Posts: 628
- Joined: Wed Nov 18, 2015 3:44 pm
- Location: Yeovil Somerset UK
Re: Axle
Just keep going until you strip a thread then back it off 1/4 turn. Been good for me for 50 years
Re: Axle
Been wrenching all my life and I just don't work that way especially where there's an axle and bearings involved .knockdolian wrote:Just keep going until you strip a thread then back it off 1/4 turn. Been good for me for 50 years
- knockdolian
- Posts: 628
- Joined: Wed Nov 18, 2015 3:44 pm
- Location: Yeovil Somerset UK
Re: Axle
Yes, it was a bit of light humour.
- The Mindless Philosopher
- Posts: 422
- Joined: Mon Jul 04, 2016 3:24 pm
Re: Axle
I see this was a few weeks ago, but for the sake of others who might need this, don't forget to set the pinch bolt, afterward.